ROE ELKO RAUH II A 2200µF 40V Electrolytic Capacitor – Industrial Workhorse
Ever had that sinking feeling when your legacy GE drive or ABB control panel starts acting up? Chances are, it’s drying out electrolytic caps like this ROE ELKO RAUH II A causing the headache. These aren’t flashy components – they’re the unsung heroes keeping older industrial systems humming in factories where downtime means real money. We’ve pulled hundreds of these from Foxboro FBM200 series modules and GE VMIVME chassis that kept running way past their expected lifespan.
| Spec Category | ROE ELKO RAUH II A Details |
| Capacitance/Voltage | 2200µF ±20% / 40V DC (not winning any beauty contests, but gets the job done) |
| Physical Build | Radial lead, 25mm diameter x 35mm height – standard footprint for most industrial boards |
| Temp Range/Lifespan | -40°C to +85°C ambient; 2000 hours @85°C (we’ve seen them last 5+ years in cooler cabinets) |
| Common Failures | Top vent bulging, electrolyte leakage – classic signs of capacitor aging in high-heat zones |
Where You’ll Actually Find These Fighting the Good Fight
Honestly? These caps are buried deep in systems nobody wants to replace – like that stubborn GE VMIVME-7750 in your paper mill that’s been running since the 90s, or the Foxboro FBM203 modules keeping your wastewater plant online. We’ve pulled them from Woodward 9907 controllers on gas turbines and ABB DSQC robot drives where the original caps finally gave up after 15 years. If your legacy system uses 40V bus lines and needs bulk capacitance (think older PLC power supplies or servo drive filters), this is probably the part number on those bulging cylinders. Seen one customer swap these into a vintage Reliance Electric DC drive – brought it back from the dead for under $50.
Why Bother With ‘Old-School’ Electrolytics?
Look, nobody picks these for new designs – polymer or film caps are better these days. But when you’re maintaining 20-year-old Emerson OVATION systems or Triconex safety controllers? This is your reality. The real advantage here is compatibility: drop this into any board expecting a standard 25x35mm radial cap and it’ll fit like the original. Personally, I’ve found the RAUH II series holds up better than generic replacements in high-ripple applications – seen them survive near exhaust manifolds on generator sets where cheaper caps dry out in months. Just don’t expect miracles: the ±20% tolerance means they’re for smoothing, not precision timing, and that 2000-hour rating assumes perfect conditions (which never happen in real plants). Still, for keeping critical legacy systems alive until budget approval comes through? Hard to beat the cost-to-reliability ratio here.
There are no reviews yet.